How to use
Shock Build
SpringRithm requires four measurements in order to characterize the shock. These measurements are used in order to run the program and then tell you where to set the coil nuts in order to hit the desired loads. The video shows you each of these measurements:
Maximum Center-to-Center
Maximum Spring Height
Stack Slider Thickness
Shock Shaft Diameter
Setup Parameters
The setup parameters is information that you should receive from your chassis manufacture or shock guy. This information all comes from your "ride height" numbers - not your dynamic numbers. These measurements include:
Install Center-to-Center (C2C)
Install Load
Gas Pressure
LR Only: Extended C2C
Test Page
The test page is where most of the time is spent. Once the shock build is entered it does not change unless a different shock is being tested.
​
The test page is where endless springs can be smashed instantly. Once you have entered the spring and height, select test.
Under results, the left hand side shows the measurements to set the coil nut, meanwhile, the right hand side shows the dynamic loads this shock will see in travel.
